On Jun 30, 10:57 am, explor <bhaves
...@gmail.com> wrote:
> Hi Gurus,
> I'm trying jumpstart T2K server and it fails with following error:
> {0} ok boot /pci@780/pci@0/pci@1/network@0 -s
> Boot device: /pci@780/pci@0/pci@1/network@0 File and args: -s
> Manual Configuration: Host IP, boot server and filename must be
> specified
> ERROR: boot-read fail
> I checked the show-nets and watch-nets to make sure the NIC is
> connected and has the right MAC address defined in the jumpstart
> server.
> {0} ok cd /pci@780/pci@0/pci@1/network@0
> {0} ok .properties
> local-mac-address 00 14 4f 82 41 46
> mac-addresses 00 14 4f 82 41 46
> grep t2k1 /etc/ethers
> 00:14:4f:82:41:46 t2k1.domain.com
> Jumpstart server is fine.
> I did goolging but couldn't find the answer. Any Help is greatly
> appreciated.
> TIA
This is a shot in the dark, but who knows.
My company purchased 2 T5120's a few months ago, long story short,
BOTH servers had faulty power distribution units (these were brand
spankin' new from Sun). Once Sun replaced the parts...BAMMM, I was
able to jumpstart as I would of expected.
I don't know if this is a new server you are talking about, the T5120
is some what based off the T2000, so I just thought I would share.
I would get the same error you get when I try to jumpstart my T5120's
If it does not help you, I'm sure someone else with a T5120 will have
the same issue as I did.
-DR
